The Dimplex Elda is a straight forward, no nonsense electric fire. Supplied with a choice of coals and pebbles the clean, stainless steel effect finish has an air of sophistication and quality. The realistic Optiflame fire sits comfortably above the pleasingly curved fret to create a smooth, functional and well rounded fire that is neat, tidy and will suit any fireplace design.
Fire: Stainless steel effect finish
Compatibility: Suitable for use with wooden, marble, granite and limestone surrounds
Flame Effect: Optiflame
Bed Type: Natural coal or pebbles
Fuel Type: Electric fire
Heat Output: 1kW and 2kW heat settings. Also includes a flame effect only setting
Assembly: None required
Fitting: If fully inset the fire requires a recess of 55mm. It can also fit flat to the wall using the spacer provided
Frequently Asked Questions
The fire has no effect or the effect has changed in appearance.?
Ensure mains switch is switched on. Check the fuse is OK and circuit breaker is also on. If the effect motor is still operating and heat is available, the lamps may have failed. Check and replace bulbs if necessary.
The fire has no heat.?
Ensure mains switch is switched on. Check the fuse is OK and circuit breaker is also on. Check the heat selector switches are switched on. If the fire has a thermostat check that this is not on the lower settings. If the room is warm enough, the thermostat will stop the fire switching the heat on. You could also check if the fire has been inadvertently covered in which case the safety cut-out may have operated? Switch your fire off, leave for 2 minutes and then switch back on.
The heat cuts out after short period of time.?
If the fire has a thermostat, check that this is not on the lower settings. If the room is warm enough, the thermostat will stop the fire switching the heat on.
The remote control is not operating correctly.?
If the fire is operative on manual but the remote is not working then simply check or replace batteries.
Is there any more information about this fire?
For additional up-to-date information, use the Dimplex website www.dimplex.co.uk
The bulb in my Dimplex Stove has stopped working. Can I replace it?
Yes, you can simply replace the bulb with an equivalent energy saving model that you can purchase from your local DIY store.
Are the plugs easily accessible if plugged in behind the fire?
Fires must not be plugged in anywhere behind the surround or the fire. The plug must remain accessible after installation to allow the fire to be isolated in an emergency.
Can’t find the answer you’re looking for?. Our experts are here to help!
Write a Review
Fireplace World wants to hear from you!